Attach the terminal ends and your DIY waterproof electronics battery box is complete. Connect the inline fuse wire and the ground wire. Now slide over the 3 inch piece of adhesive heat shrink tube. Use the two inline heat shrink connectors Crimp and heat the one side to seal. You will now pick 2 wires from the 4 to pair. ![]() Once the cable gland is installed slide the cable with the connector through from the exterior. Once the pilot hole is drilled use the step drill bit to ream out the hole until the cable gland will thread in. In this install I opted for the front under the handle. I would say avoid the top the bottom and the back. This will be the location of the cable penetration. Next drill a pilot hole using a 1/8″ drill bit. This will hold the battery in place so it doesn’t bounce around. Using pipe insulation fit the battery to the box.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |